Full Automatic Door Opener Kit including Two x DDA 900-1 Hard-wired Wheelchair / Push To Open Stainless Steel Push Pads and DIGIWAY PLUS Power Swing Door Opener.
Important - please read:
This operator is for domestic, office, disabled access and low traffic doors only and not medium or high traffic doors.
It must be operated by push buttons* only and must not be pushed or pulled manually - this will invalidate the Products Warranty
It is not suitable for Outward Opening external doors
It is not suitable for Fire Rated Doors
* handheld fobs or activation sensors are also suitable
What's in the kit?
|1 x ||DWPS102U ||Digiway Power Swing door opener with universal arm for an inward or outward opening door |
|2 x ||SS51 ||692 mm Monitored Safety sensors |
|1 x ||LAS9070 ||Finger guard to prevent crushed fingers in door hinges |
|1 x ||SIGN-003 ||Self-adhesive Keep clear sign |
|1 x ||SIGN-005 || |
Self-adhesive Power Assisted Door / Push Button To Open sign
2 x DDA 900-1 Hard-wired Wheelchair / Push To Open Stainless Steel Push Pads
Please note: damage to the motor drive circuits of the DWPS102U caused by incorrect use (pushing and pulling of the door while in motion) is not covered under warranty as this is deemed as abuse. If you require an Automatic Door opener for free/manual door use ( that can be pushed or pulled with the need to press a button) please choose the Spring Return opener code: DWSR
102U ** THIS KIT CONTAINS THE DWPS102U (Power To Open / Power To Close) Door Opener**
PLEASE READ THE FOLLOWING BEFORE PURCHASING:
is a Power To Open / Power To Close door opener and must be used in conjunction with Push Pads, Activation Sensors, Remote KeyFobs etc. Although the DWPS102U does have a "Push & Go" Feature it cannot be used as a Free Door *.
which is a Power To Open / Spring Closing door opener is designed specifically for customers that require a Free Door * and also can be used in conjunction with Push Pads, Activation Sensors, Remote KeyFobs etc.* A Free Door requires no power to open or close and can be used without Push Pads, Activation Sensors, Remote KeyFobs etc.Full installation manuals can be downloaded from this website please read and understand both products to assess which product is better suited for your application.
2. The door must have no resistance while opening/closing and all such devices should be removed these include door closers, spring assistance, draft excluders, weathers strips etc. not doing so will damage the equipment and invalidate the Products Warranty.
3. Consideration must be given if fitting a locking device to ensure enough room is available after the automation is fitted.
4. JWS always recommend fitting a Safety Sensor and a Fingerguard to Automatic Doors it is the installers responsibility to ensure the equipment is installed, commissioned and maintained to EN16005 Standards.
5. Always undertake a full site Risk Assessment before purchasing Automatic Door Equipment, and consult with a Fire Safety Officer where necessary.
Need advice? Call us on 01761 414700
Safety is essential to protect persons from physical harm if they approach Automatic Doors. JWS can advise you on the requirements to comply with EN16005 (the standard for Automatic Door safety) but the installer and purchaser is responsible for conducting a Risk Assessment and that the equipment is installed and maintained to these standards.
Please call us for a free, no obligation chat and download the EN16005 Summary Guide HERE
Purchasing Automatic Door Equipment from JWS is done so on the understanding that you or your installer is suitably qualified to specify, install and maintain automatic doors.
JWS always recommend fitting a finger guard and the correct safety sensor.